We're excited to be moving to a bigger shop. R-Delta is opening a co-working shop that will enable likeminded DIYers and makers to work...

We're finally able to get the ECM Transmit lamp working on DCS. Thanks to David Malmstrom who contributed the code to get the ECM lamp...

Here's how you can integrate the backlighting of the F16 MISC Panel from R-Delta to sync with other panels on your rig using whatever...

This is a video I took while testing the F16 MISC Panel prototype on DCS. I'll post another test video using a production version and...

The DIY Resin Pilot lamp is now ready to be installed and tested. We wired the pilot lamp and installed it on our F16 MISC Panel modified...

Out first batch of F16 MISC had a successful takeoff. There are pre orders already for the next batch so it looks like we’ll be busy...

With our F16-Misc panel fully assembled, it’s time to integrate it into our rig for testing. We began by securely mounting the panel onto...

We're almost done building our F16-MISC Panel. We've finalized the enclosure design after building our board (in the last video). We now...

We're now working on the F16-MISC Panel electronics. We've designed and assembled the prototype board and should be ready to assemble...

We're working on our next project, the F16 MISC PANEL, that we hope to also include in our product line. So far we have started our...

I decided to take a video while building an ICP while fulfilling an order. You'll see how I use resin casting, resin printing, 3D...

And we're finally ready to ship out! Hey! Thank you for waiting. Took a while but we're now ready to take orders and ship out your ICPs....

Here's a short video of our final test before we proceed with production. This is of course the prototype we've been handling and...

Hey! We're testing the proto. And it's looking good. Just some final touches on the buttons there. We may start production next week. ...

We revised the light board so we get all text evenly lighted. The new light board covers the entire faceplate and is laminated in the...

Hey all! Sorry if we didn't post a video update as we hoped to do on a weekly basis. To be honest, the documentation (video) has been...

Here's an update, still a lot is going-on on the faceplate. We made several approach and this seems to be it. We have the markings...

We're now in the home-stretch! And it's a looonng stretch. Doing all the aesthetic features: surface finish, markings, backlighting and...

We're now working on the button action. Having difficulty sourcing the right spring. Deciding how much resistance and action (movement)...

We're looking at replacing the acrylic faceplate of the ICP with Epoxy Resin. This will help us improve mass production speed but we'll...